There are many negative effects that lead to the negative effects of the application of high-quality pu timing belts. It will inevitably cause belt damage in the long run. It cannot be used normally. When using industrial timing belts, it is inevitable to encounter common failures of machinery and equipment. At this point, one must grasp the reason for its harm, so that the difficulty can be identified and solved immediately:

1. Insufficient tension:
If the tensile force is insufficient, the sliding friction force will be insufficient, then there will be a dragging situation, which will increase the damage of the non-standard timing belt, damage the load capacity of other transmission systems, and cause the belt transmission system to be unbalanced.

2. Too much tension:
The tension of the synchronous belt is too large and the deformation is serious, which will reduce the service life of the synchronous belt.

3. There are debris left on the synchronous belt:
Be careful if it contains vegetable oils and other stains, because the stains contain compounds that can enter the timing belt and damage the material structure.

4. The synchronous pulley is not aligned:
If the synchronous pulley is not aligned, it will cause the synchronous belt to slip, twist, and heat and wear inside, so the synchronous pulley must be aligned.

5. The lengths of the synchronous belts are not equal: if the lengths of a row of belts are not equal, the tension force on each synchronous belt will be different, and some will slip or the tension will be too large, so that the synchronous belt Wear occurs. Therefore, be sure to use the same type of synchronous belt when using it.

6. The wheel groove of the synchronous pulley is worn:
If the synchronous pulley is used for too long, the wear of the groove edge will increase, and the angle will be incorrect. The synchronous belt will touch the bottom end of the groove. In order to drive the machine, the tension must be increased.